Conditions for Running the DTC

P0741

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, P0741, P0742, P2763, or P2764 is not set.
• Engine speed is 400-7,500 RPM or greater for 5s.
• Ignition voltage is 9-32V.
• Transmission fluid temperature is between -6.7 to +130°C (+20 to +266°F).
• Throttle position is 8% or greater.
• Engine torque is 50 N.m (36 lb ft) or greater.
• Engine torque signal is valid.
• Throttle position signal is valid.
• TCM detects the transmission gear ratios listed below for the commanded gear when TCC is commanded ON:
  • 2nd gear ratio is between 2.75-3.17.
  • 3rd gear ratio is between 1.78-2.04.
  • 4th gear ratio is between 1.35-1.55.
  • 5th gear ratio is between 0.93-1.07.
  • 6th gear ratio is between 0.70-0.80.
• DTC runs continuously when the above conditions are met.

P0742

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, P0741, P0742, P2763, or P2764 is not set.
• Engine speed is 400-7,500 RPM for 5s.
• Ignition voltage is 9-32V.
• Transmission fluid temperature is between 15-130°C (59-266°F).
• Calculated throttle position was 10% or greater and has not dropped below 2%.
• Engine torque signal is valid.
• Throttle position signal is valid.
• Engine torque is 60 N.m (44 lb ft) or greater.
• Vehicle speed greater than 1 km/h (0.6 MPH).
• TCC is commanded OFF.
• Engine torque signal is valid.
• Throttle position signal is valid.
• DTC runs continuously when the above conditions are met.