Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P0722

DTC P0101, P0102, P0103, P0121, P0122, P0123, P0716, P0717, P0722, or P0723 is not set.
Ignition voltage is 9-32V.
Engine speed is 400-7,500 RPM for 5s.
Engine torque signal is valid.
Throttle position signal is valid.
Transmission input speed is between 1,000-8,191 RPM.
Calculated throttle position is 8% or greater.
Engine torque is 30 N.m (22 lb ft) or greater.
Transmission fluid temperature is -40°C (-40°F) or greater.
DTC runs continuously when the above conditions are met.

P0723

DTC P0101, P0102, P0103, P0121, P0122, P0123, P0723, P0973, P0974, P0976, or P0977 is not set.
Ignition voltage is 9-32V.
Greater than 5s since last transmission upshift or downshift.
Engine speed is 400-7,500 RPM for 5s.
DTC runs continuously when the above conditions are met.

P077C

P077D