Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify the scan tool ISS/OSS Supply Voltage parameter displays OK.
- If OK is not displayed
Refer to Circuit/System Testing.
- If OK is displayed
- If OK is not displayed
- Verify the scan tool Transmission OSS parameter changes with vehicle speed or does not drop out, while operating the vehicle at 16-32 km/h (10-20 MPH).
- If the Transmission OSS does not vary with vehicle speed or drops out
Refer to Circuit/System Testing.
- If the Transmission OSS varies with vehicle speed and does not drop out
- If the Transmission OSS does not vary with vehicle speed or drops out
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.