Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0716
- DTC P0101, P0102, P0103, P0121, P0122, P0123, P0716, P0717, P0752, P0973, or P0974 is not set.
- Vehicle speed is 10 km/h (6 MPH) or greater.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- Engine torque signal is valid.
- Throttle position signal is valid.
- DTC runs continuously when above conditions are met.
P0717
- DTC P0717, P0722, or P0723 is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- Vehicle speed is 16 km/h (10 MPH) or greater.
- Engine torque is 50 N.m (37 lb ft) or greater.
- DTC runs continuously when above conditions are met.
P07BF or P07C0
- Ignition voltage is 9-32V.
- DTC runs continuously when above condition is met.