Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.

NOTE:

You must perform the Circuit/System Verification first.

Ignition OFF, remove the Q8 Control Solenoid Valve Assembly.
Place the Q8 Control Solenoid Valve Assembly on a clean work surface near the transmission assembly.
Connect the DT-48616-10 adapter harness between the vehicle harness connector and the Q8 Control Solenoid Valve Assembly connector. Ignition ON.
Test for 11-13V between the ISS 12V circuit terminalB on the Q8 Control Solenoid Valve Assembly X3 connector and ground.
- If not between 11-13V
  Replace the Q8 Control Solenoid Valve Assembly.
- If between 11-13V
Verify the scan tool Transmission ISS parameter is between 495-505 RPM when performing the input shaft speed test. Refer to Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test .
- If not between 495-505 RPM
  Replace the Q8 Control Solenoid Valve Assembly.
- If between 495-505 RPM
Verify there is no damage to the reluctor, which is attached to the 4-5-6 clutch and 3-5-R clutch housing assembly, or misalignment between the B14C Transmission Input Shaft Speed Sensor and reluctor.
- If the reluctor is damaged or misaligned
  Repair or replace as necessary.
- If the reluctor is not damaged or misaligned
Replace the B14C Transmission Input Shaft Speed Sensor.