Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0711
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0658, P0668, P0669, P06AD, P06AE, P0711, P0712, P0713, P0716, P0717, P0722, P0723, P0962, P0963, P0966, P0967, P0970, P0971, P215C, P2720, P2721, P2729, or P2730 is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- Accelerator position signal is valid.
- Engine torque signal is valid.
- Brake torque is not active.
- DTC runs continuously when above conditions are met.
P0712
- DTC P0712, P0716, P0717, P0722, or P0723 is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- DTC runs continuously when above conditions are met.
P0713
- DTC P0713, P0716, P0717, P0722, or P0723 is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- DTC runs continuously when above conditions are met.