Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P06AC
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0658, P0668, P0669, P06AC, P06AD, P06AE, P0712, P0713, P0716, P0717, P0722, P0723, P0962, P0963, P0966, P0967, P0970, P0971, P215C, P2720, P2721, P2729, or P2730 is not set.
- Throttle position signal is valid.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- Engine torque signal is valid.
- DTC runs continuously when the above conditions are met.
P06AD
- DTC P06AD, P0716, P0717, P0722, or P0723 is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- DTC runs continuously when the above conditions are met.
P06AE
- DTC P06AE is not set.
- Engine speed is 400-7,500 RPM for 5s.
- Ignition voltage is 9-32V.
- DTC runs continuously when the above conditions are met.