LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transmission - 6T40 - DTC P0601 To DTC P0971) >> Diagnostic Information and Procedures >> DTC P0667, P0668, or P0669: Control Module Temperature Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON.
  2. Verify the scan tool TCM Temperature parameter is between -254 and +254°C (-425 and +489°F).
    • If not between -254 and +254°C (-425 and +489°F)  

      Replace the Q8 Control Solenoid Valve Assembly.

    • If between -254 and +254°C (-425 and +489°F)  
  3. Verify the scan tool TCM Temperature parameter increases greater than 2°C (3.6°F) after operating the vehicle at 64 km/h (40 MPH) for 10 min.
    • If the temperature does not increase greater than 2°C (3.6°F) 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If the temperature increases greater than 2°C (3.6°F) 
  4. Verify the scan tool Transmission Fluid Temperature and TCM Temperature parameters are within 20°C (36°F) of each other.
    • If the temperatures are not within 20°C (36°F) 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If the temperatures are within 20°C (36°F) 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals