Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0114 P0116, P0117, P0118, P0119, P0121, P0122, P0123, P0125, P0128, P012B, P012C, P012D, P0191, P0192, P0193, P0222, P0223, P0443, P0449, P0452, P0453, P0454, P0502, P0503, P0601, P0606, P0722, P0723, P16F3, P1104, P1221, P2100, P2101, P2102, P2103, P2135 are not set.
The ignition voltage is between 11-32V.
The engine OFF time is greater than 8h.
The barometric pressure (BARO) is greater than 70kPa.
The fuel level is between 10-90%.
The startup engine coolant temperature (ECT) is less than 35°C (95°F).
The startup intake air temperature (IAT) is between 4-34°C (39-93°F).
DTC P0496 runs once per cold start, for up to 17 min, when the above conditions are met. This test will run with the purge valve and the vent valve closed.