Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTC P0101, P0102, P0103, P0107, P0108, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0128, P0201-P0204, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0300, P0351, P0352, P0353, P0354, P0412, P0418, P0420, P0606, P0641, P0651, P124A, P124B, P2147, P2148, P2150, P2151, P2153, P2154, P2156, P2157, P2430, P2431, P2432, P2433, P2435, P2436, P2437, or P2438 is not set.
- Greater than 60 min has elapsed since the last cold start.
- Ignition voltage is between 10-32V.
- Engine speed is less than 5,000 RPM.
- Intake air temperature (IAT) is greater than -10°C (+14°F).
- Engine coolant temperature (ECT) is between -10 and +56°C (14-133°F).
- Barometric pressure (BARO) is greater than 74kPa (10.7 psi).
- Manifold absolute pressure (MAP) sensor is greater than 20kPa (2.9 psi).
- Mass air flow (MAF) is less than 50g/s.
- Secondary air injection pump is commanded ON.
- DTC P0411 runs once per ignition cycle when the above conditions are met for greater than 7s.