Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0335 Condition 1

The ECM does not detect a crankshaft position sensor pulse for greater than 4s.

Condition 2

The ECM does not detect a crankshaft position sensor pulse for greater than 1.0s.

Condition 3

The ECM does not detect a crankshaft position sensor pulse for 2 out of 10 engine revolutions.

P0336 Condition 1

The ECM detects that 10 or more crankshaft resynchronization have occurred within 10.0s.

Condition 2

The ECM does not detect the synchronization gap on the reluctor wheel for greater than 0.4s.

Condition 3

The ECM does not detect the synchronization gap on the reluctor wheel for 1.5s after the starter was engaged.

Condition 4

The ECM detects less than 51 or greater than 65 crankshaft position sensor pulses during 1engine revolution for 8 out of 10 engine revolutions.