Conditions for Running the DTC

P0133

• DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0128, P0131, P0132, P0134, P0201, P0202, P0203, P0204, P0300, P0411, P0412, P0418, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496 are not set.
• The engine coolant temperature (ECT) is hotter than 70°C (158°F).
• The Ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• The engine run time is greater than 120s.
• The engine speed is between 1,000-3,500 RPM.
• The device controls are not active.
• The HO2S heaters have been ON for greater than 40s.
• The intake air temperature (IAT) is hotter than -40°C (-40°F).
• The fuel composition is less than 87 percent ethanol.
• The barometric pressure is greater than 70kPa.
• The fuel control is not in power enrichment.
• Decel fuel cut-off is not active.
• The Mass Airflow (MAF) Sensor parameter is between 14-40g/s.
• The fuel state is in Closed Loop.
• DTCs P0133 runs once per drive cycle when the above conditions are met for 3s.

P013A

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• Engine run time is equal to or more than 40s.
• DTCs P013E and P2270 have run and passed.

  THEN

• DFCO is active.
• The accelerator pedal position (APP) is stable.
• This DTC runs once per trip.

P013B and P013F

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• DTCs P013A, P013E, P013F, P2270, and P2271 have run and passed.
• DTCs P013B and P013F run once per trip.

P013E

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• DTC P2270 has run and passed.

  THEN

• DFCO is active.
• The APP is stable.
• This DTC runs once per trip.

P015A and P015B

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
• The Ignition voltage is between 10-32V.
• The engine coolant temperature (ECT) is hotter than 70°C (158°F).
• The intake air temperature (IAT) is hotter than -40°C (-40°F).
• The HO2S heater is on for greater than 180s.
• The fuel level is greater than 10 percent.
• The engine run time is greater than 120s.
• The engine speed is between 1,000-2,300 RPM.
• The vehicle speed is between 51-120 kph (31.7-74.6 mph).
• The mass airflow (MAF) is between 3-12g/s.
• The device controls are not active.
• The evaporative emission (EVAP) diagnostics are not in control of purge.
• The predicted catalytic converter temperature is between 600-900°C (1,112-1,652°F).
• The fuel system is in Closed Loop.
• The DTCs run once per drive cycle when the above conditions are met.

P2270

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
• The ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• The pedal position is less than 4 percent.
• The engine speed is between 1,250-2,300 RPM.
• The engine airflow is equal to or greater than 3g/s and equal to or less than 12g/s.
• The vehicle speed is equal to or greater than 55 km/h (34.2 mph) and equal to or less than 120 km/h (74.6 mph).
• The fuel state is in Closed Loop.
• The evaporative emission (EVAP) diagnostics are not in control of purge.
• The HO2S heaters are ON for more than 180s.
• The predicted catalytic converter temperature is between 600-900°C (1,112-1,652°F).
• This DTC runs once per trip when all of the above conditions have been met for 1s.

P2271

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270 are not set.
• The ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• The engine speed is 1,250-2,300 RPM.
• The engine air flow is between 3-12g/s.
• The vehicle speed is between 55-120 kph (34.2-74.6 mph).
• The fuel state is in Closed Loop.
• The EVAP is not in control of purge.
• Power take-off is not active.
• The HO2S heaters have been on greater than 180s.
• The predicted catalyst temperature is between 600-900°C (1,112-1,652°F).
• DTCs P013A, P013E, and P2270 have run and passed.

  THEN

• DFCO is active.
• The APP is stable.
• This DTC runs once per trip when the above conditions are met for 3s.