Conditions for Running the DTC

P0131 and P0137

• DTCs P0106, P0107, P0108, P0201, P0202, P0203, P0204, P0411, P0412, P0418, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496 are not set.
• The engine is operating in Closed Loop .
• The Ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• The ethanol content is less than 87 percent.
• Device controls are not active.
• Decel fuel cut-off is not active.
• DTC P0131 runs when the above conditions are met for 5s.

P0132

• DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0201, P0202, P0203, P0204, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496 are not set.
• The engine is operating in Closed Loop .
• The Ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• Engine run time is greater than 195s.
• The ethanol content is less than 87 percent.
• Fuel control state is not in power enrichment.
• DTC P0132 runs when the above conditions are met for 5s.

P0134 and P0140

• DTCs P0068, P0101, P0102, P0103, P0120, P0121, P0122, P0123, P0220, P0222, P0223, P1516, P2101, P2119, P2135, P2176 are not set.
• The Ignition voltage is between 10-32V.
• The engine run time is greater than 150s.
• The fuel composition is less than 87 percent ethanol.
• DTCs P0134 and P0140 run continuously when the above conditions are met.

P0138

• DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0201, P0202, P0203, P0204, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496 are not set.
• The engine is operating in Closed Loop .
• The Ignition voltage is between 10-32V.
• The fuel level is greater than 10 percent.
• Engine run time is greater than 110s.
• Ethanol content is less than 87 percent.
• Fuel control state is not in power enrichment.
• DTC P0138 runs when the above conditions are met for 5s.

P2A00

• DTCs P0068, P0106, P0107, P0108, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P1516, P2101, P2119, P2135, P2176 are not set.
• The engine run time is greater than 100s.
• The engine speed is between 500-3,400 RPM.
• The Ignition voltage is between 10-32V.
• The Mass Airflow (MAF) is between 3.2-30g/s.
• The ECT is hotter than 70°C (158°F).
• DTC P2A00 runs continuously when the above conditions are met for 5s.