LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Controls And Fuel - 2.4L - DTC P0114 To DTC P0604) >> Diagnostic Information and Procedures >> DTC P0116: Engine Coolant Temperature (ECT) Sensor >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the B34 Engine Coolant Temperature Sensor.
  2. Test the ECT sensor by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance (ECT Sensor) table. The resistance values should be in range of the table values.
    • If not within the specified range 

      Replace the B34 Engine Coolant Temperature Sensor.

    • If within the specified range 
  3. Test for infinite resistance between each terminal and the sensor housing.
    • If less than infinite resistance 

      Replace the B34 Engine Coolant Temperature Sensor.

    • If infinite resistance 
  4. All OK.