Transmission Adaptive Values Learn: Troubleshooting
WARNING: This page is about a different variant/trim than selected.
If the Transmission Adaptive Values Learn will not run and the above stated conditions have been met, ensure the following:
- Determine if transmission is Gen 1, Gen 2, or Gen 3.
- Verify vehicle model year.
- Verify transmission fluid temperature is between the temperatures listed above for the vehicle model year and generation of transmission.
- Brakes and brake switch are functioning properly
- No active DTCs
- Closed throttle and engine RPM increases above 1,500 RPM while at entrance of the test
- Park/Neutral position switch is properly adjusted and functioning
- Line pressure control is able to provide 1,000 kPa and is within specifications
- Vehicle is not moving or vibrating excessively
- Clutches are properly assembled
NOTE:
Gen 1 and Gen 2 may have the same RPO code. The generation of transmission can be determined by using a scan tool to check for Specific DTC P0842. If DTC does not show Invalid, the transmission is Gen 1. If DTC shows Invalid, transmission is Gen 2.