Powder Method
WARNING: This page is about a different variant/trim than selected.
- Thoroughly clean the suspected leak area using a rag.
- Apply an aerosol type leak tracing powder to the suspected leak area.
- Operate the vehicle for 15-20 minutes under city driving conditions until normal operating temperatures are reached.
- Shut OFF the engine.
- Inspect the suspected leak area.
- Trace the leak path through the powder in order to find the source of the leak.
- Make the necessary repairs.
CAUTION:
Do not clean using brake cleaner or other reactive solvents as these solvents can damage rubber gaskets, seals and bushings.
NOTE:
Do not idle vehicle, this will not actuate transmission systems, and do not drive the vehicle on the freeway as this will splatter oil inhibiting leak diagnosis.