LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Automatic Transmission - 6T40 - DTC P0973 To DTC P2764 And Troubleshooting Procedures) >> Diagnostic Information and Procedures >> DTC P2714 or P2715: Pressure Control Solenoid Valve 4 Stuck Off/On >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    WARNING:

    Refer to Parking Brake and Drive Wheels Warning .

    NOTE:

    If other DTCs are set, diagnose those DTCs first.

  1. Ignition ON.
  2. Verify DTC P0716, P0717, P0722, P0723, P077C, P077D, P07BF, or P07C0 was not set by reviewing the scan tool Freeze Frame/Failure Records data.
    • If none of the DTCs were set 
  3. Engine idling, transmission in Park, with parking brake applied and drive wheels chocked.
  4. Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
    • If the transmission fluid level and condition is not correct 

      Repair as necessary.

    • If the transmission fluid level and condition is correct 
  5. Ignition ON, clear the TCM DTCs with a scan tool.
  6. Verify DTC P2714 or P2715 does not set while performing a road test. Refer to Road Test .
    • If DTC P2714 or P2715 sets 

      Refer to Circuit/System Testing.

    • If DTC P2714 or P2715 does not set 
  7. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  8. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  9. All OK.
scientia non olet · About LEMON Manuals