LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement (LEA) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine mount bracket Refer to Engine Mount Bracket Replacement (LUK) .
  2. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  3. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  4. Disconnect the oxygen sensor harness from the front cover and reposition.
    5. Fig 1: Water Pump Bolt
    GM2624609Courtesy of GENERAL MOTORS COMPANY
  5. Remove the engine front cover to water pump bolt (1).
    6. Fig 2: Engine Front Cover Bolts
    GM2624620Courtesy of GENERAL MOTORS COMPANY
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Remove the engine front cover bolts (1).
  8. Remove the engine front cover.
    9. Fig 3: Engine Front Cover Gasket
    GM2624623Courtesy of GENERAL MOTORS COMPANY
  9. Remove and discard the engine front cover gasket (1).
scientia non olet · About LEMON Manuals