LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Drive Belt Replacement (LUK) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
    2. Fig 1: View Of Tensioner Stop Fastener And Stop
    GM2284553Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The tensioner stop is critical and must be removed prior to compressing the drive belt tensioner spring.

  2. Remove the tensioner stop fastener (1) and stop (2).
    3. Fig 2: Identifying Drive Belt
    GM1809412Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Make sure the EN- 48932  compressor tool is not on the generator bracket and A/C compressor bracket.

  3. Install the EN-48932  compressor (1) to the drive belt tensioner spring.
  4. Compress the drive belt tensioner spring fully using the EN-48932  compressor.
  5. Reposition the idler pulley (2) to release tension off the drive belt.
  6. Remove the drive belt from under the middle idler pulley.
  7. Remove the drive belt (3) from the vehicle.
scientia non olet · About LEMON Manuals