Engine Flywheel Installation
WARNING: This page is about a different variant/trim than selected.
Special Tools
- EN-38122-A Crankshaft Balancer Holder
- EN-43653 Flywheel Holding Tool
- EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools .
- Install the flywheel.
- Install NEW bolts.
- Holding the crankshaft balancer with EN-38122-A holder , tighten the bolts evenly. Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the EN-45059 meter
CAUTION:
Refer to Fastener Caution .
NOTE:
EN-43653 flywheel holding tool may be used instead of EN-38122-A holder in order to prevent crankshaft rotation.