Conditions for Running the DTC

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0114, P0116, P0117, P0118, P0121, P0122, P0123, P0201, P0202, P0203, P0204, P0222, P0223, P0300, P0301, P0302, P0303, P0304, P0335, P0336, P0351, P0352, P0353, P0354, P0641, P0651, P0697, P06A3, P2122, P2123, P2127, P2128, P2135, and P2138 are not set.
The engine coolant temperature (ECT) is between -12 to +56°C (10-132°F).
The calculated 3-way catalyst temperature is colder than 500°C (932°F).
The barometric (BARO) pressure is greater than 75 kPa.
The engine control module (ECM) will exit the diagnostic if the calculated 3-way catalyst temperature is greater than 1,000°C (1832°F) when the engine run time is greater than 17s.
Vehicle speed is less than 1.6 km/h (1 MPH).
The accelerator pedal is not depressed.
The ECM will exit the diagnostic if the engine run time is greater than a calibrated value.
This DTC runs within the first 15s of start-up. This diagnostic runs once per trip when a cold start has been determined.