LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 2.0L (LTG) - DTC P0010 To DTC P0333 >> Diagnostic Information and Procedures >> DTC P0243, P0245, or P0246: Turbocharger Wastegate Solenoid Valve >> Circuit/System Verification

Circuit/System Verification

  1. Ignition On
  2. Verify a series of clicks, which increase in frequency, are heard or felt from the Q42 Turbocharger Wastegate Solenoid Valve when commanding the Turbocharger Wastegate Solenoid Valve between 15-100% with a scan tool.
    • If a series of clicks in increasing frequency are not heard or felt 

      Refer to Circuit/System Testing.

    • If a series of clicks in increasing frequency is heard or felt 
  3. Verify the parameters listed below do not display Malfunction when commanding the Turbocharger Wastegate Solenoid Valve between 15-100% with a scan tool.
    • Turbocharger Wastegate Solenoid Valve Control Circuit High Voltage Test Status
    • Turbocharger Wastegate Solenoid Valve Control Circuit Open Test Status
    • Turbocharger Wastegate Solenoid Valve Control Circuit Low Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • If Malfunction is not displayed 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify a DTC does not set.
    • If a DTC sets 

      Refer to Circuit/System Testing

    • If a DTC does not set 
  6. All OK
scientia non olet · About LEMON Manuals