Component Testing

Static Test

1. Ignition OFF, disconnect the harness connector at the K111 Fuel Pump Driver Control Module.
2. Connect a DMM, set on the diode setting, with the positive lead at terminal 16 and the negative lead at terminal 9 of the K111 Fuel Pump Driver Control Module
3. Test for 0.4-0.8V between terminal 16 and terminal 9.
   • If not between 0.4-0.8V 

     Replace the K111 Fuel Pump Driver Control Module.

   • If between 0.4-0.8V 
4. Connect a DMM, set on the diode setting, with the positive lead at terminal 9 and the negative lead at terminal 16 of the K111 Fuel Pump Driver Control Module
5. Test for OL between terminal 9 and terminal 16.
   • If not OL 

     Replace the K111 Fuel Pump Driver Control Module.

   • If OL 
6. All OK