LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 2.0L (LTG) - DTC P0010 To DTC P0333 >> Diagnostic Information and Procedures >> DTC P0133, P013A, P013B, P013E, P013F, P015A, P015B, P2270, or P2271: HO2S >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON.
  2. Verify no HO2S heater DTCs are set. If a DTC is set Refer to Diagnostic Trouble Code (DTC) List - Vehicle.

    If a DTC is set

    Refer to Diagnostic Trouble Code (DTC) List - Vehicle.

  3. Verify none of the conditions listed below exist:
    • Lean or rich fuel injectors-Refer to Fuel Injector Diagnosis.
    • Water intrusion in the HO2S harness connector
    • Low or high fuel system pressure-Refer to Fuel System Diagnosis.
    • Fuel that is contaminated-Refer to Alcohol/Contaminants-in-Fuel Diagnosis.
    • Fuel saturation of the evaporative emission (EVAP) canister
    • Exhaust leaks
    • Engine vacuum leaks
    • Engine oil consumption-Refer to Oil Consumption Diagnosis.
    • Engine coolant consumption-Refer to Loss of Coolant.

    If any of the above conditions exist

    Repair as necessary.

    If none of the conditions exist

  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify the DTC does not reset.

    If the DTC sets

    Test or replace the appropriate B52 HO2S.

    If the DTC does not set

  6. All OK.