Component Testing
- Ignition OFF, disconnect the harness connector at the B34 Engine Coolant Temperature Sensor.
- Test the ECT sensor by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Engine Coolant Temperature Sensor
table. The resistance values should be in range of the table values.
- If not within the specified range
Replace the B34 Engine Coolant Temperature Sensor.
- If within the specified range
- If not within the specified range
- Test for infinite resistance between each terminal and the sensor housing.
- If less than infinite resistance
Replace the B34 Engine Coolant Temperature Sensor.
- If infinite resistance
- If less than infinite resistance
- All OK.