Circuit/System Verification
- Ignition ON.
- Verify DTC P0685 or P1682 is not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- If none of the DTCs are set
- If any of the DTCs are set
- Command the Fuel Pressure Regulator ON and OFF with a scan tool while observing the following control circuit status parameters:
- Fuel Pressure Regulator Control Circuit High Voltage Test Status
- Fuel Pressure Regulator Control Circuit Open Test Status
- Fuel Pressure Regulator Control Circuit Low Voltage Test Status
- Fuel Pressure Regulator High Control Circuit High Voltage Test Status
- Fuel Pressure Regulator High Control Circuit Open Test Status
- Fuel Pressure Regulator High Control Circuit Low Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing.
- If OK or Not Run is displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- If the DTC does not set
- If the DTC sets
- All OK