LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 2.0L (LTG) - DTC P0010 To DTC P0333 >> Diagnostic Information and Procedures >> DTC P0010, P0013, or P2088-P2091: Camshaft Position Actuator Solenoid Valve >> Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
  2. Test for 7-12Ω between the control terminal 1 or A and the low reference circuit terminal 2 or B.
    • If not between 7-12Ω 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If between 7-12Ω 
  3. Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
    • If not infinite resistance 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If infinite resistance 
  4. All OK.
scientia non olet · About LEMON Manuals