LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Engine Oil Cooler Replacement (FWD) >> Installation Procedure

Installation Procedure

    Fig 1: Engine Oil Cooler
    GM2874859Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    A NEW engine oil cooler seal must be used whenever reinstalling the engine oil cooler.

  1. Install the engine oil cooler (1).
    2. Fig 2: Engine Oil Cooler Connector
    GM2874857Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

  2. Install the engine oil cooler connector (3) and tighten to 50 N.m (37 lb ft).
  3. Install the oil cooler hose (1) and (2).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the oil cooler fastener (1) and tighten to 10 N.m (89 lb in)
  5. Install the engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
scientia non olet · About LEMON Manuals