LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Automatic Flex Plate Attaching Bolts
    GM2726718Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.

  1. Install the automatic flex plate (2) and hand start NEW bolts (1).
    2. Fig 2: Starter Motor Bolts
    GM2744964Courtesy of GENERAL MOTORS COMPANY
  2. To prevent crankshaft rotation, install EN 46106  holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flex plate.
    3. Fig 3: Flex Plate Bolt Tightening Sequence
    GM2744962Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Tighten the bolts evenly using the following procedure:
    1. Tighten the bolts a first pass in sequence to 20 N.m (15 lb ft).
    2. Tighten the bolts a second pass in sequence to 30 N.m (22 lb ft).
    3. Tighten the bolts a final pass in sequence 40 degrees using the EN 45059  meter.
  4. Remove EN 46106  holding tool.
  5. Install the transmission. Refer to TRANSMISSION REPLACEMENT (AWD) or TRANSMISSION REPLACEMENT (FWD) .
scientia non olet · About LEMON Manuals