Fuel Rail and Injectors Removal (LTG)

Special Tools 

EN-49248  Fuel Rail Assembly Remover

For equivalent regional tools, refer to Special Tools

Fig 1: Fuel Injection Fuel Rail Noise Shield
Courtesy of GENERAL MOTORS COMPANY
NOTE:

Replace the noise cancelling foam component if it is exposed to and has absorbed automotive fluids.

1. Remove the fuel injection fuel rail noise shield (1).
Fig 2: Identifying Fuel Rail Assembly Remover Studs
Courtesy of GENERAL MOTORS COMPANY
2. Disconnect the electrical harness from the fuel rail harness connection.
3. Remove the fuel rail assembly retaining bolts and upper rubber grommet, if necessary.
NOTE:

Use care to avoid contact with the fuel rail harness during special tool installation and fuel rail removal.

4. Install EN-49248  studs (1) into the 2 outermost fuel rail assembly retaining bolt locations. Tighten the studs to 22 N.m (16 lb ft).
5. Install EN-49248  remover (2) onto each stud, and engage the hooks to the fuel rail. Install the nuts (3) retaining the remover onto the studs and tighten until snug.
Fig 3: Fuel Rail Assembly Remover
Courtesy of GENERAL MOTORS COMPANY
NOTE:
EN-49248 will assist in the proper removal of the fuel rail assembly. Ensure that the following conditions are met:
• Turn the handles simultaneously in order to pull the fuel rail straight out along the fuel injector axis.
• DO NOT twist when pulling out on the fuel rail and injector assembly.
6. Using EN-49248  remover , remove the fuel rail assembly.