LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P06DA-P06DC: Engine Oil Pressure Control Solenoid Valve >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON.
  2. Verify the parameters listed below do not display Malfunction when commanding the Engine Oil Pressure Control Solenoid Valve On and Off with a scan tool.
    • Engine Oil Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status
    • Engine Oil Pressure Control Solenoid Valve Control Circuit Open Test Status
    • Engine Oil Pressure Control Solenoid Valve Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • If Malfunction is not displayed 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals