Turbocharger Coolant Feed Pipe Replacement (LTG)

Fig 1: Turbocharger Coolant Feed Pipe (LTG)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716) . Remove the catalytic converter. Refer to CATALYTIC CONVERTER REPLACEMENT (LTG) . NOTE: Replace hose clamp if necessary. Special Tools BO-38185 Hose Clamp PliersFor equivalent regional tools, refer to Special Tools .
1	Turbocharger Coolant Feed Pipe Bolt Tighten 35 N.m (26 lb ft)
2	Turbocharger Coolant Feed Pipe Washer (Qty:2) NOTE: Install 2 NEW washers.
3	Turbocharger Coolant Feed Pipe Fastener (Qty:2) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
4	Gasket
5	Hose Clamp
6	Turbocharger Coolant Feed Pipe