Conditions for Setting the DTC

B097B 00

• The voltage seen at the BCM monitored switch does not match the voltage seen at the keyless entry control module monitored switch.
• The above condition exists for more than 1 s.

B097B 02

• The control module detects a short to ground in the ignition mode switch signal circuit.
• The above condition exists for more than 1 s.

B097B 04

• The control module detects a open in the ignition mode switch signal circuit.
• The above condition exists for more than 1 s.

B097B 05

• The control module detects an open in the ignition mode switch signal circuit.
• The above condition exists for more than 1 s.

B097B 08

• The control module detects a change in the ignition mode without observing a switch press.
• The above condition occurs 4 consecutive times.

B097B 61

• The control module detects a continuously closed ignition mode switch.
• The above condition exists for more than 1 min.