LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> Molex Connectors >> Terminal Insertion Procedure

Terminal Insertion Procedure

After the terminal is replaced, perform the following procedure in order to insert the terminal.

  1. Slide the new terminal into the correct cavity at the back of the connector.
  2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Insure that the terminal is locked in place by gently pulling on the wire.
  3. To assemble the connector, reverse the connector disassembly procedure.
scientia non olet · About LEMON Manuals