Circuit/System Verification
- Ignition ON.
- Verify that DTC C028A, C028B, or C028F is not set.
- If any of the DTCs are set
- Program the K83 Parking Brake Control Module. Refer to Electronic Parking Brake Control Module Programming and Setup .
- Ignition ON.
- Apply and release the park brake.
- Verify the DTC is not set.
- If the DTC is set, replace the K83 Parking Brake Control Module.
- If the DTC is not set
- All OK.
- If none of the DTC are set
- All OK.