Removal Procedure
- Turn the ignition OFF.
- Apply the brake pedal several times until the brake pedal becomes firm to deplete the power vacuum brake booster vacuum reserve.
Courtesy of GENERAL MOTORS COMPANY
- Disconnect the power brake booster vacuum pipe quick connect (1) .
Courtesy of GENERAL MOTORS COMPANY
- Disconnect the power brake booster vacuum sensor electrical connector.
- Release the power brake booster vacuum rear pipe from the retainer (1) on the dash panel.
- Remove the power brake booster vacuum rear pipe vacuum sensor and check valve (2) from the power vacuum brake booster.
Courtesy of GENERAL MOTORS COMPANY
- Remove the power brake booster vacuum rear pipe from the retainers (1) on the dash panel.
- Release the power brake booster vacuum rear pipe from the retainer (2) on the right front brake pipe.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the right front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement
.
Courtesy of GENERAL MOTORS COMPANY
- Release the power brake booster vacuum rear pipe retainer (1) from the power brake booster pump bracket.
- Disconnect the power brake booster vacuum rear pipe quick connect (2) .
- Remove the power brake booster vacuum rear pipe from the vehicle.