Conditions for Setting the DTC

B3205 00, B3210 00 

The BCM has detected that the compatibility code stored in the affected window motor does not match the compatibility code stored in the BCM.

B3205 39, B3210 39 

An internal malfunction has been detected by the BCM in the power window motor while commanding the window UP or DOWN.

B3205 42, B3210 42 

The BCM will automatically attempt to download the calibration program into the appropriate window motor (As will occur when the window motor has been replaced), if the first calibration program fails to load, the BCM will attempt to download the calibration program a second time. If this download fails, the BCM will set appropriate DTC.

B3205 4B, B3210 4B 

The BCM detects that a window motor is "not normalized" which will occur under the following conditions:

• When the battery has been disconnected
• When the battery has been replaced
• When the door wiring harness has been disconnected
• When the window motor has been disconnected.