Circuit/System Testing
NOTE:
Because of the accessibility of the switches, perform the switch component testing before beginning the circuit/system testing.
- Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the M69 Sunroof Motor. It may take up to 2 minutes for all vehicle systems to power down.
- Test for less than 10Ω between the ground circuit terminal 2 and ground.
- If 10Ω or greater
- Ignition OFF, disconnect the harness connector at the M69 Sunroof Motor.
- Test for less than 2Ω in the ground circuit end to end.
- If 2Ω or greater, repair the open/high resistance in the circuit.
- If less than 2Ω, repair the open/high resistance in the ground connection.
- If less than 10Ω
- Verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
- If test lamp does not illuminate and the circuit fuse is good
- Ignition OFF.
- Test for less than 2Ω in the B+ circuit end to end.
- If 2Ω or greater, repair the open/high resistance in the circuit.
- If less than 2Ω, verify the fuse is not open and there is voltage at the fuse.
- If the test lamp does not illuminate and the circuit fuse is open
- Ignition OFF.
- Test for infinite resistance between the B+ circuit and ground.
- If less than infinite resistance, repair the short to ground on the circuit.
- If infinite resistance, replace the M69 Sunroof Motor.
- If the test lamp illuminates
- Ignition ON.
- Test for less than 1V between the signal circuit terminals listed below and ground:
- Terminal 3 - M69 Sunroof Motor
- Terminal 5 - M69 Sunroof Motor
- Terminal 6 - M69 Sunroof Motor
- If 1V or greater
Repair the short to voltage on the signal circuit.
- If less than 1V
- Ignition OFF.
- Test for infinite resistance between the signal circuit terminals listed below and ground:
- Terminal 3 - M69 Sunroof Motor
- Terminal 5 - M69 Sunroof Motor
- Terminal 6 - M69 Sunroof Motor
- If less than infinite resistance
Repair the short to ground on the signal circuit
- If infinite resistance
- Disconnect the harness connector at the S72 Sunroof Switch and the S88 Sunroof Tilt Switch.
- Test for less than 5Ω between the circuit terminals listed below:
- S72 Sunroof Switch terminal 1 and M69 Sunroof Motor terminal 3
- S72 Sunroof Switch terminal 4 and M69 Sunroof Motor terminal 5
- S88 Sunroof Tilt Switch terminal 1 and M69 Sunroof Motor terminal 3
- S88 Sunroof Tilt Switch terminal 4 and M69 Sunroof Motor terminal 6
- If greater than 5Ω
Repair the open/high resistance in the circuit.
- If less than 5Ω
- Test or replace the M69 Sunroof Motor.