Front Bumper Fascia Replacement

Fig 1: Front Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the front wheelhouse liner screws to fascia. Refer to Front Wheelhouse Front Liner Replacement .
1	Front Bumper Fascia Upper Bolts (Qty:8) CAUTION: Refer to Fastener Caution . Tighten 3 N.m (27 lb in)
2	Front Bumper Fascia Plastic Retainer (Qty:4)
3	Front Bumper Fascia Procedure Carefully push a small nylon wedge between the front bumper fascia and the front bumper fascia guide. Insert a small flat-bladed tool into the front bumper fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide. Disconnect any electrical connectors. Transfer components as necessary.