LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Energy Absorber Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Front Bumper Energy Absorber
    GM2193768Courtesy of GENERAL MOTORS COMPANY
  1. Position the front bumper energy absorber on the vehicle.
    2. Fig 2: Front Bumper Energy Absorber Fasteners
    GM2193766Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Use only the original front bumper energy absorber fastener. Replace fastener if damaged.

  2. Install the 4 front bumper energy absorber fasteners (1) and tighten to the front compartment front inner side rail 115 N.m (85 lb ft).
    3. Fig 3: Identifying Drill Holes
    GM2193769Courtesy of GENERAL MOTORS COMPANY
  3. Drill two holes (1) 6mm (0.24in) along the edges of the front bumper energy absorber.
    4. Fig 4: Two Drill Holes
    GM2193770Courtesy of GENERAL MOTORS COMPANY
  4. Drill two holes (1) 6mm (0.24in) along the edges of the front bumper energy absorber.
    5. Fig 5: Front End Upper Tie Bar Fastener
    GM2193771Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use only the original front end upper tie bar fastener (M6 bolt and nut). Replace the fastener if damaged.

  5. Install the 2 front end upper tie bar fasteners (1) and tighten to the front compartment front inner side rail 22 N.m (16 lb ft).
    6. Fig 6: Upper Front End Tie Bar Fastener
    GM2193772Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use only the original front end upper tie bar fastener (M6 bolt and nut). Replace the fastener if damaged.

  6. Install the 2 front end upper tie bar fasteners (1) and tighten to the front compartment front inner side rail 22 N.m (16 lb ft).
  7. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems .
  8. Install all related panels and components.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Without Start/Stop) .
  10. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals