Removal Procedure

Up/Down or In/Out Adjustment

1. Open the rear door.
Fig 1: Door Side Upper and Lower Hinges
Courtesy of GENERAL MOTORS COMPANY
CAUTION:

Refer to Paint Damage Caution .

NOTE:

The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.

2. Apply masking tape to the fender and the door edges.

   Loosen the door side hinge bolts in the specified sequence (1,2,3,4).

   Do not remove the bolts from the door.

3. Adjust the door up or down by repositioning the door as needed.
4. Adjust the door in or out by repositioning the door as needed.

Fore/Aft Adjustment

Fig 1: Hinge Pillar Side Bolts (Rear Door)
Courtesy of GENERAL MOTORS COMPANY
CAUTION:

Refer to Paint Damage Caution .

NOTE:

The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.

1. Apply masking tape to the fender and door edges.

   Loosen the body side hinge bolts in the specified sequence (1,2,3,4).

   Do not remove the bolts from the door.

2. Adjust the door fore and aft by repositioning the door as needed.