Disarming an Armed System/Silencing an Alarm

If system arming has been requested, it must be disarmed before the vehicle is opened again.

NOTE:

Disconnecting the battery or removing fuses does not disable the arm or alarm modes, since the BCM stores the content theft deterrent mode status in memory.

To disarm the content theft deterrent system in standby mode, perform one of the following:
- Press the UNLOCK button on the keyless entry transmitter.
- Approach the vehicle with a valid keyless entry transmitter and press the exterior door handle button (RPO ATH).
- Insert a valid key into the ignition and switch to the ON position.
To disarm the content theft deterrent system in the armed mode (non-event) or when activated (during an alarm event):
- Press the UNLOCK button on the keyless entry transmitter.
- Insert a valid key into the ignition and switch to the ON position