Component Testing

Fuel Door Latch

1. Ignition OFF, disconnect the harness connector at the M97 fuel door lock actuator.
2. Install a 25A fused jumper wire between one of the control terminals and 12V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the M97 fuel door lock actuator should perform the LOCK and UNLOCK function.
   • If the actuator does not perform the LOCK and UNLOCK function 

     Replace the M97 fuel door lock actuator.

   • If the actuator performs the LOCK and UNLOCK function 
3. All OK