Component Testing

Trunk Release Switch

1. Ignition OFF, disconnect the harness connector at the S58A Rear Compartment Lid Unlatch Switch-Exterior.
2. Test for infinite resistance between the signal circuit terminal 1 and the ground circuit terminal 3 with the switch in the open position.
   • If less than infinite resistance 

     Replace the S58A Rear Compartment Lid Unlatch Switch-Exterior.

   • If infinite resistance 
3. Test for less than 3Ω between the signal circuit terminal 1 and the ground circuit terminal 3 with the switch in the closed position.
   • If 3Ω or greater 

     Replace the S58A Rear Compartment Lid Unlatch Switch-Exterior.

   • If less than 3Ω 
4. All OK