Windshield Washer Solvent Container Filler Tube Replacement

Preliminary Procedure

1. Open and support the hood.
2. Reach into the engine compartment at the windshield washer solvent container fill tube side and grasp the fill tube neck.
3. With a slight turn and upward pull, remove the fill tube from the top of the windshield washer solvent container.
4. Inspect the fill tube grommet in the top of the washer container.

Procedure

1. Lubricate the end of the fill tube with clean windshield washer solvent prior to installing the fill tube into the top of the windshield washer container.
2. Slowly press the fill tube neck into the windshield washer container seal.
3. Ensure the top of the fill tube tab locks into the tab on the front compartment fuse block housing.
4. Once connected, push downward in order to engage the fill tube.