Component Testing

Relay Test

1. Ignition OFF, disconnect the appropriate relay.
2. Test for 60-200Ω between terminals 85 and 86.
   • If less than 60 or greater than 200Ω 

     Replace the relay.

   • If between 60-200Ω 
3. Test for infinite resistance between the terminals listed below:
   • 30 and 86
   • 30 and 87
   • 30 and 85
   • 85 and 87
   • If less than infinite resistance 

     Replace the relay.

   • If infinite resistance 
4. Test for less than 5Ω between terminals 30 and 87A.
   • If 5Ω or greater 

     Replace the relay.

   • If less than 5Ω 
5. Install a 10A fused jumper wire between relay terminal 85 and 12V. Install a jumper wire between relay terminal 86 and ground.
6. Test for less than 5Ω between terminals 30 and 87.
   • If 5Ω or greater 

     Replace the relay.

   • If less than 5Ω 
7. All OK