LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC B255D: Passenger Compartment Lamp Control 2 Circuit >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, exterior lamps OFF, disconnect the harness connector at the appropriate E55 flood lamp.
  2. Connect a test lamp between the control circuit terminal 1 and ground.
  3. Verify the test lamp turns ON and OFF when commanding the Accent Lighting ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the X1 harness connector at the K9 body control module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2Ω in the control circuit end to end.
      • If 2Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2Ω, replace the K9 body control module.
    • If the test lamp is always ON 
    1. Ignition OFF, disconnect the X1 harness connector at the K9 body control module, ignition ON.
    2. Test for less than 1V between the control circuit terminal and ground.
      • If 1V or greater, repair the short to voltage on the circuit.
      • If less than 1V, replace the K9 body control module.
    • If the test lamp turns ON and OFF 
  4. Test or replace the appropriate E55 flood lamp.
scientia non olet · About LEMON Manuals