LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2012 >> Regal Turbo, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> Diagnostic Information and Procedures >> Stop Lamps Malfunction >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON, observe the scan tool Brake Pedal Switch parameter while applying and releasing the brake pedal. The parameter should change between Active and Inactive when changing between the selected states.
    • If the parameter does not change between the selected states, refer to the Brake Pedal Position Sensor Malfunction in Circuit/System Testing .
  2. Observe the left and right stop lamps while pressing and releasing the brake pedal. The stop lamps should turn ON and OFF when changing between the selected states.
    • If the left or right stop lamps do not change between the selected states, refer to the Stop Lamp Malfunctionin Circuit/System Testing .
  3. Observe the center high mount stop lamp while pressing and releasing the brake pedal. The center high mount stop lamp should turn ON and OFF when changing between the selected states.
    • If the center high mount stop lamp does not change between the selected states, refer to Center High Mount Stop Lamp Malfunction in Circuit/System Testing .
scientia non olet · About LEMON Manuals