LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2012 >> Regal Turbo, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> Diagnostic Information and Procedures >> DTC B3884 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the E6 center high mounted stop lamp.
  2. Test for less than 30 Ω between the ground circuit terminal 1 and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  3. Connect a test lamp between the control circuit terminal 2 and ground.
  4. Ignition ON, turn the center high mounted stop lamp ON and OFF by applying and releasing the brake pedal. The test lamp should turn ON and OFF when changing between the selected states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  5. If all circuits test normal, replace the E6 center high mounted stop lamp.
scientia non olet · About LEMON Manuals