Ignition and Start Switch Replacement

Fig 1: Ignition & Start Switch

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
1	Ignition and Start Switch Bolt CAUTION: Refer to Fastener Caution . Tighten 1.5 N.m (13 lb in)
2	Steering Wheel Theft Deterrent Lock TIP: The steering wheel theft deterrent lock is not present on vehicles with AN3.
3	Ignition and Start Switch Bolt Tighten 1.5 N.m (13 lb in)
4	Ignition and Start Switch Procedure Disconnect any electrical connectors as needed. Disconnect the key in ignition switch from the ignition lock cylinder case.